Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Love my shop heater..... *LINK*

Posts

Love my shop heater..... *LINK*

#1

Love my shop heater..... *LINK*

Devon Palmer

>Hey,

I've seen a few posts around of people asking about shop heat. I have one of these and love it. I used this in my old shop where the temp would hang down between 40-50. I had it above the lathe out of the path of "most" of the chips, at an angle so they wouldn't collect, and I could easily work without a shirt due to the radiant nature of the heat. Much cheaper than gas (at todays rates) and no exposed flame. I blow it out before I turn it on each day.


Marvin Overhead Quartz heater

Re: Love my shop heater..... *LINK*

#2

Re: Love my shop heater.....

Carole Valentine

>I have two of those hanging from the ceiling...one at my back and one at the front of the NOVA where I can also swing it around and aim it at my Jet mini. They do warm you up, but at 1500 watts each (on high) plus the halogen light, I suspect they also make the electric meter go nuts. I turn them on if I am going to only be a short time in the shop or while waiting for the kero heater to warm things up. I also have a heated floor mat at my lathe that keeps my feet toasty on the concrete floor. It has two settings, low and high, but I find that low is fine. When my feet are warm, the rest of me is much happier!

Re: Love my shop heater..... *LINK*

#3

Re: Love my shop heater.....

arw01

>Take a look at your last electric bill, use the highest rate and figure your cost per hour from there.

The marvin would run me about .11 an hour here in Spokane WA. Out in Moses Lake where Yahoo and Microsoft are building data centers it would be about .03 an hour. Gee I wonder why they are building there!

Alan