Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Candle Twist Work

Posts

Candle Twist Work

#1

Candle Twist Work

John Morovich

>Attended a demo by Dennis Ligget on Twist work back in the Spring. Finally got sometime to practice and trying to get it right. I have a very nice pile of firewood kindling, the attached picture are a few candle sticks that did not hit the wood bin. These sticks are cherry with an oil finish. Most of the wood bin was popar and maple. Need more pratice but there fun and a challenge to make. The triple twist bines are not very uniform ( need more practice) but it works foe me.


img

Re: Candle Twist Work

#2

Re: Candle Twist Work

Larry In Lima

>I really like the middle one. I don't know anything about these, and havent' searched the net yet, but do you have a link or an article I can check out on these? Thanks for showing them, really nice! Larry

Re: Candle Twist Work

#3

Re: Candle Twist Work

John Morovich

>Don't know of any links, Stuart Mortimer has a book on Spiral Work. And I have seen a video tape from a British woodturning series on twist work. Wish I could be more helpful. Dennis Liggett's demo was great. He say he was putting something together to be published in the AAW magazine. I hope it's soon.

Re: Candle Twist Work

#4

Re: Candle Twist Work

John Lucas

>Good Job. An open twist is one thing I've never done. Seeing your work may give me the boost to do one.

Re: Candle Twist Work

#5

Re: Candle Twist Work

Dennis Daudelin

>There are lots of different ways to make the spiral; by hand, with a Legacy Mill or with a mix of tools.

This is the only link that I've seen of one method to make the hollow spirals, other than the demos on the Legacy Woodworking site.

http://home.att.net/~waterfront-woods/Articles/SpiralCandle.pdf

Good luck,

Dennis


img

Re: Candle Twist Work

#6

Re: Candle Twist Work

George Van

>I am impressed John, cherry sure seems to go well with twisted candlesticks. I like the proportions of the one in the middle best also but they are all great looking.

Re: Candle Twist Work

#7

Re: Candle Twist Work

John Morovich

>to hollow out the material I drill using a 3/8 long bore hand bit before I start my twist work. Then use a combination of a barley twist gouge and as the hollows deepen, I do a final cut with a arbortec 4" blade and then take out the remaining material with a set of carving skews. Its all sanding from there.