Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Turning Tool Rack Idea...

Posts

Turning Tool Rack Idea...

#1

Turning Tool Rack Idea...

Peter Teubel

>While turning, I have nowhere to put my tools other than the lathe bed. Since my shop floor isn't level (and therefore the lathe isn't either), they just roll off the bed. To save 5 steps to my tool cabinet (hey, time is money...well, it used to be and old habits die hard), I whipped this holder together this afternoon. Works great. The tools are always within reach. The pendant arm is more than strong enough to support the minimal extra weight.




Re: Turning Tool Rack Idea...

#2

Re: Turning Tool Rack Idea...

Mark Mandell - Gone Round In Jersey

>Peter,

Looks good!

I would suggest you consider adding restraining bar(s) to prevent the tools from falling out even with the slant you built in. It's just me, but I don't like loose pieces of sharp steel floating around while spinning wood on the lathe.

M

Re: Turning Tool Rack Idea...

#3

Re: I built a stand on an old rolling....

Jamie Donaldson

>.. chair base and included a magnetic holder(knife rack type)diagonally across the top. Works like a champ!

Re: Turning Tool Rack Idea...

#4

Re: Turning Tool Rack Idea...

Allen Neighbors

>I think it's a fine rack, Peter, as long as the pendant arm will hold it. :o)

Nice work... good thinking, too.

Allen

Re: Turning Tool Rack Idea...

#5

Now That's a Cool Idea, Pete !

Ruth Niles

>

Re: Turning Tool Rack Idea...

#6

Re: Turning Tool Rack Idea...

George Van

>I like your idea Peter; do you have any concerns on the arm supporting the weight of the tools and rack? I will have to try a similar errrr �copy�. Thanks for posting.

Re: Turning Tool Rack Idea...

#7

Re: Turning Tool Rack Idea...

Peter Teubel

>None whatsoever. IMO, the pendant arm is overbuilt for its original function anyway.

Re: Turning Tool Rack Idea...

#8

Thanks Peter

George Van

>