Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Flame or Chatoyance? for pen turners...

Posts

Flame or Chatoyance? for pen turners...

#1

JL

Flame or Chatoyance? for pen turners...

JL

>and anyone else who cares to answer. Can flame or chatoyance show up on pens? I was making a table out of some makore. The flat pieces had this hiding in it (see below). Would the flame or chatoyance show up in such a small scale or would it take a larger piece? Do you lose the flame marks when you go round? The pic below is of a roughly 4" x 12" piece from one of the aprons.


img

Re: Flame or Chatoyance? for pen turners...

#2

Re: Flame or Chatoyance? for pen turners...

Terence Rice

>Going round won't lose the flame but on such a small piece as a pen it probably won't show up very well.

Re: Flame or Chatoyance? for pen turners...

#3

Re: Flame or Chatoyance? for pen turners...

Ron in Drums PA

>Sometimes you get lucky, sometimes you don't.

I've noticed that if you cut the wood cross grain and not as a spindle, there is a better chance of saving the chatoyance.

Re: Flame or Chatoyance? for pen turners...

#4

Re: Flame or Chatoyance? for pen turners...

Carole Valentine

>Obviously the smaller the piece the harder it is to preserve figure and chatoyance but it can be done. I struggle with this a lot on my miniatures, but most of the time I can find a way to orient the wood so I can keep at least some of the lights.

Re: Flame or Chatoyance? for pen turners...

#5

JL

Re: Thanks for your responses.

JL

>