Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Does anyone have this sander? *LINK*

Posts

Does anyone have this sander? *LINK*

#1

Does anyone have this sander? *LINK*

Allen Neighbors

>I'm curious if anyone has tried this sander from CSUSA. It says average CFM is 2.5. Do you know if that is true? My compressor will keep up well, at that rate.

Thanks in advance.


Apprentice Air Sander

Re: Does anyone have this sander? *LINK*

#2

Re: Does anyone have this sander?

Donna Banfield

>Allen, that sander looks very similar to the Sioux 5201 ROS that I purchased from Craft Supplies about 3 years ago. They don't seem to carry the Sioux anymore(based on a keyword search on their website), so I can't tell you what the specs were by comparison. However, I originally tried to run the Sioux ROS using a small Porter Cable Compressor, and the sander bogged down OFTEN and stalled. When this happened, it put more scratches in your turning.

I eventually upgraded the compressor to a 60 gallon Husquvarna, and have had no problems. I now use that one and the Grex for sanding in the higher grits. I prefer the Grex because the handle is smaller and fits better in my smaller hand -- less fatigue.

I have no background in the technology and engineering part, but with just my experience, I would question whether that ROS could run adequately using a small compressor. Even at 60 gallons 11CFM, the compressor kicks on after about a minute and runs for a few minutes after I stop sanding. But it never bogs down or stalls.

Re: Does anyone have this sander? *LINK*

#3

Re: Does anyone have this sander?

Thad

>I believe I remember seeing the Souix in a recent Packard catalogue. It may be a different model though...or I could just be having "one of those days."

~ Thad

Re: Does anyone have this sander? *LINK*

#4

Re: Does anyone have this sander?

eliot d

>I agree with what Donna has said. I use the Grex with a modest Porter Cable compressor ,and it cycles a lot. It's doable , but the compressor runs on and on.

Re: Does anyone have this sander? *LINK*

#5

Re: I gave up. Finally just

Allen Neighbors

>ordered the Sioux 8800ES from Packard, and a 3" starter kit from Vince. Tired of pussyfooting around; and really tired of getting my knuckles barked by bark.

Hope I'm not disappointed in the Sioux.

Thanks, everyone, for the information. :o)

Re: Does anyone have this sander? *LINK*

#6

Re: Better Choice

Mark Mandell - Gone Round In Jersey

>Far cheaper to run and way quieter. Just remember to keep it clean. Send it for warranty repair with wood and abrasive dust in it and they'll just send it back to you.

With a few exceptions, I gave up on the air tool thing years ago.

m

Re: Does anyone have this sander? *LINK*

#7

Re: Does anyone have this sander?

Bill Hale / Woodspinner

>Allen

I use a Sioux electric and a Harbour Freight air.

I like them each about the same. HF air unit about $ 40.00.

My only problem with an air unit is I am running a compressor to run a air unit. ??? efficiency.

Good turning and be safe

Bill in Casa Grande, AZ.