Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Large flat surfaces...

Posts

Large flat surfaces...

#1

Steven Antonucci

Large flat surfaces...

steve antonucci

>I've turned a few big platters and I was wondering how everyone goes about making the "field" of the platters "dead-flat"? No little pips in the middle, or wavies when viewed at an angle...

Seems that there are tradeoffs between cutting (harder to control the little wavies) and scraping (cleaning up tearout).

What cuts/tools/methods do you all use?

Steve

Re: Large flat surfaces...

#2

Re: Large flat surfaces...

Barbara Gill, Remlik VA

>I use a teardrop scraper. Sometimes I will mark areas that need to come off. When the marks are gone, I check the surface.

Re: Large flat surfaces...

#3

Re: Large flat surfaces...

Wally Dickerman in Arizona

>My method...I use a sanding block with a small radius. Apply oil to the problem area, and using 80 or 120 sandpaper sand until all of the lumps are gone. As long as the area between the lumps has visible oil, the lump is still there. When no more oil shows, the surface is smooth. Only takes a few minutes, and it works very well.

Wally

Re: Large flat surfaces...

#4

Ric Taylor

Re: Large flat surfaces...

Ric Taylor

>I do the same thing as Wally, except I use a 4" sanding disk and make continuous very light passes. Light passes cause the sandpaper to only contact the raised areas. It doesn't take long, and the results are good.

I found that a 3" disk was too small for me for this application, so I cut a 5" disk down to 4", and it works fine.

Ric

Re: Large flat surfaces...

#5

Re: Large flat surfaces...

Russ Fairfield

>I made a little T-Square that I can hold under the tool. The short leg indexes to the back side of the tool rest. I set the tool rest square with the lathe and the work is flat with a couple light cuts.

Caninet scrapers also work. So does a Random Orbit Sander.

HINT:

Flat surfaces look flatter if they have a slight hump in the middle. All it takes is a few 1/000ths.

Re: Large flat surfaces...

#6

Re: Large flat surfaces...

Brian Simmons, Heflin, AL

>I have done several 24" diameter lazy susans as well as large platters. What works well for me; I clamp a small pair of vice grips to my round nose scraper. I use the vise gripes as a depth stop against the tool rest. Holding it rigidly, I sway my hips along the cut.

Re: Large flat surfaces...

#7

Re: Large flat surfaces...

john lucas

>Good Idea Brian. Of course you have to have the tool rest perfectly square. For perfectly flat areas I take a piece of wood cut to fit inside the flat area and trued up with a handplane. Then I'll mark the high areas and take them off.

I like Wally's method although I had trouble keeping the bottom perfectly flat. It did make a perfectly smooth line from lip to center which is perfect for platters. I'll try it again with a slightly radiused sander and see if it works better for me. I used my normal sanding block which is about 4" long. I was turning a platter about 14" when I tried the sandpaper method.