Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Aniline Dye & Watco Compatability

Posts

Aniline Dye & Watco Compatability

#1

Aniline Dye & Watco Compatability

Tom Minehan

>I have a piece that contains both bare and dyed wood. I would like to finish the bare wood with Watco Teak Oil. Will this create problems with the dyed wood. The dye is alcohol based.

Re: Aniline Dye & Watco Compatability

#2

Re: Aniline Dye & Watco Compatability

Jennifer@Indy.USA

>Tom,

This is something I've been wondering as well. I look forward to the responses to your question. Thanks for asking it!

Jen

Re: Aniline Dye & Watco Compatability

#3

Re: Aniline Dye & Watco Compatability

Jim Shaver Oakville, Ont.

>Hi Tom,

I have used Aniline dyes before on some of my furniture to bring out and enhance the look of the figure in the wood. I then applied Watco over it and then a few top coats, this is an example of what it looked like on curly maple. I hade no problems.

Photobucket - Video and Image Hosting

Take care,

Jim

Re: Aniline Dye & Watco Compatability

#4

Re: Aniline Dye & Watco Compatability

Mark Mandell - Gone Round In Jersey

>Tom,

Dye stains are applied to the wood and their carrier (water or alk) is allowed to evaporate. Once the wood is dry, you are free to apply an oil finish or even oil-based stain. The only potential incompatibility is in the carriers - oil vs. water - so while you can't mix them before applying, you can apply them to the same wood so long as you apply the dye first and allow it to dry well before proceeding.

m

Re: Aniline Dye & Watco Compatability

#5

Re: Aniline Dye & Watco Compatability

tek-Brunswick, Ohio

>Any Oil based finish or Lacquer works, but not water based lacquer. The dye will bleed into water or alcohol based finishes.

Re: Aniline Dye & Watco Compatability

#6

Thanks !!

Tom Minehan

>

Re: Aniline Dye & Watco Compatability

#7

Pretty stunning Jim

Michael Stadulis, in Gloucester County, NJ

>any suggestions on the best clock face and movement suppliers for me?

-Mike

Re: Aniline Dye & Watco Compatability

#8

Re: Pretty stunning Jim

Jim Shaver Oakville, Ont.

>Hi Michael,

I buy locally from Murray Clock(www.murrayclock.com) or Colonial Times(www.colonialtimes.com). I know there are better suppliers in terms of quality, but they have always given me great service.

Take care,

Jim