Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Powermatic 4224 Problems. HELP

Posts

Powermatic 4224 Problems. HELP

#1

Powermatic 4224 Problems. HELP

OB OBrien

>Hi you all; A friend of mine has a Powermatic 4224. The drive pulley on the spindle came loose and caused the belts to misalign. He attempted to fix it by loosening the set screws and driving the spindle left to right in order to slip the pulley off the spindle. It didn't work, it's jammed tight and he can't drive it back out right to left now. He apparently didn't realize their was a key in

the keyway,and I think it's jammed in tight now.

Can some one familiar with a powermatic tell me how to get this stuck spindle driven out so the pulley can be properly pressed off or back to the correct position. Will it come out from either direction or does it have to have a specific direction to remove it. I'm out of town so haven't seen it yet. He has asked me to come help when I get home Sunday afternoon. So I don't really know what to expect. Thanks in advance. OB

Re: Powermatic 4224 Problems. HELP

#2

Re: Powermatic 4224 Problems. HELP

Sean Troy

>Have you loosened up the collar behind the handwheel?

Re: Powermatic 4224 Problems. HELP

#3

Re: Powermatic 4224 Problems. HELP

Hooligan

>Not sure on that one, never ran into it with mine.

I would think that if you cut a two by four to slip around the spindle, you should be able to gently wedge the drive pully back off the key enough that it would loosen up. I think, too, that it would help you if you have the keyway in line with the force, at a right angle to the 2x. I think that you should be able to fit it in without forcing it, it'll be tight, but should go. You should be able to do it without further damage to the pully.

Re: Powermatic 4224 Problems. HELP

#4

Re: Powermatic 4224 Problems. HELP *LINK*

Bob Fawcett

>OB,

I have never removed mine, but I think it comes out left to right, or threaded end first. I know you have to remove the handwheel and I think there is another nut behind the wheel. Both have a set screw locking them. Here is a link to the manual with an exploded drawing of the headstock.


Manual

Re: Powermatic 4224 Problems. HELP

#5

Re: Powermatic 4224 Problems. HELP

OB O'Brien

>Thanks you all; I'm headed over to his place in a little while. Will see what I can do. Will let you all know how it worked out. Thanks OB