Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

close quarter drills

Posts

close quarter drills

#1

close quarter drills

T Daniel

>some fact and some guessing here:

I have bought and sold about 60 of the Milwaukee close quarter drills. This is what I think has happened: a number of them were assembled with poor quality Chinese bearings and these were either made to sell on ebay or were liquidated on ebay; I am not certain which. If you get one of these just replace the bearings with higher quality bearings, preferrably sealed instead of shielded and you will be ok. The main bearing that gives trouble is the one next to the fan as dust gets blown into it. You can buy a sealed Chinese bearing from Enco for about $3 each or you can get a much better bearing from a bearing company for about $10 each. I have had very good luck with these drills after replacing the bearing with a higher quality sealed one. If you wait too long to replace the bearing the plastic that supports the bearing will get hot and melt and the new bearing will do no good.

Re: close quarter drills

#2

Re: close quarter drills

eliot d

>I've been using a Milwaulkee (and also a really cheap HF $29.95 imitation) for quite a while with no problems whatsoever -- even the cheap HF. One thing I do is always blow out the unit after each grit.

Re: close quarter drills

#3

Re: close quarter drills

Devon Palmer

>I have one of the knock off drills too - outlasted my dads Sioux even. The bearings in it are noisey after a coupla years of use, but, the thing just won't die (until tomorrow when I pick it up to use it the first time - Murphys law :). I blow it out as you do. I'll just use it as a throw-away, as I've certainly gotten my money out of it.

- Devo