Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Goncalo Alves and a question...........

Posts

Goncalo Alves and a question...........

#1

Goncalo Alves and a question...........

Richard Jones

>Small plate/platter, about 7" from 4/4 material (from scrap bin!!).

After finishing, etc., I saw some cracking across the piece, but it was from one side only, not all the way through. A turning acquaintance said that had I shot it with Deft, it may not have cracked. I used DO, Bealed, Ren. Wax.

Absolutely rock hard wood that takes a beautiful polish, but seems to remain open-grained, even after finishing.

Is there a consensus to this?

Many thanks.

Richard Jones

Rice, VA


img

Re: Goncalo Alves and a question...........

#2

Back of piece......... 

Richard Jones

>


img

Re: Goncalo Alves and a question...........

#3

Re: Goncalo Alves and a question...........

Allen Neighbors

>That sort of grain responds well to wet sanding, I think. I wet sand with danish oil, and sometimes lemon oil. Danish will harden when it dries. It takes 2,099 years to dry lemon oil. :o)

When wet sanding with either oil, the small particles of dust usually fill the pores, making it seem like it's been finished, anyway.

JMHO... not necessarily the right opinion. :o)

Re: Goncalo Alves and a question...........

#4

Thanks Allen.........appreciate the help.

Richard Jones

>

Re: Goncalo Alves and a question...........

#5

Re: Richard, something else...

Allen Neighbors

>As soon as I see a small crack, regardless where I am in the turning process, I stop and grab my lacquer wash and super glue. I rub the lacquer wash (25%Lacquer/75%Thinner) over the area of the crack, and then wipe it off. I let that set just a few minutes, then I put a stream of superglue on the crack, and set the bottle down. I immediately take a cloth and wipe the excess glue away... this leaves a little CA in the crack. Then I immediately sand across the crack. This puts the sanding dust into the crack with the glue. I keep repeating the "CA, wipe excess, and sand", until the crack is flush with the surface... sometimes four or five times.

I've discovered this technique (if you can call it that) over a period of time. The cracks never open up again.

Just thought I'd throw that in. :o)

Re: Goncalo Alves and a question...........

#6

Brad Vietje

Beautiful Plate !

Brad Vietje

>