Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Tip for newbies

Posts

Tip for newbies

#1

Tip for newbies

Carole Valentine

>I was preparing a Catalpa log today between centers. Catalpa is a very soft wood and as I was going through my usual mounting prep for wood like this, I thought maybe posting my method for keeping my spur center from spinning in end grain or punky wood might help someone else.

Once you have found the point you want as center, use a forstner bit the size of your spur center to drill a shallow hole about 1/8" deep. Hammer your center in then remove it. Saturate the fresh wood in the forstner hole with thin CA glue, let it cure then tap your center back into place and carry on. The hole serves two purposes - it gives a flat surface for the spur center and it contains the CA so it doesn't run all over you. :) Works for me.

Re: Tip for newbies

#2

Re: Tip for newbies

Mike Cunningham (Cape May)

>Do you have any sort of allergic reaction to catalpa? It's the one and only wood,(knock on wood) that I've worked that causes a reaction when I'm turning. If I don't wear a respirator I sneeze my way, with itchy eyes through the turning process.

Re: Tip for newbies

#3

Re: Tip for newbies

Carole Valentine

>Not yet, but my dog is sneezing! LOL

Re: Tip for newbies

#4

Re: This Newbie says, "thanks".

Allen Neighbors

>I appreciate your posting this. I hate that infernal spur center. I can't get it to hold in Dry, Hard, Bois d'Arc! It always spins free while I'm trying to turn a tenon. I'll Super Glue the darned thing in place. Thanks for the idea. :o)

Re: Tip for newbies

#5

Re: This Newbie says, "thanks".

Carole Valentine

>Allen, you don't have to superglue it in place - you want to be able to wiggle it a bit when you mount it and position the tailstock. Just harden the wood in the area after you have made the spur impression in it. I had to knock my spur out of that catalpa with a mallet yesterday because I didn't let the glue completely set before I mounted the piece back between centers.

Re: Tip for newbies

#6

Re: Tip for newbies *LINK*

Darrell Feltmate

>Thanks from an oldie. Slap my forehead and say duh! If you do not mind I will put this one on my tips page.


Around the Woods

Re: Tip for newbies

#7

Re: Tip for newbies

Carole Valentine

>LOL! Go right ahead Darrell. Happy to share! I have benefited from your pages often, most recently by watching your videos on using a hook tool. I recently received a Kelton Hook tool (which is a bit more elaborate than most hook tools in that is has a sort of built-in adjustable clutch.) Having never used a hook tool before I started searching and found your videos to get me started. Thanks!

Re: Tip for newbies

#8

Re: Tip for newbies *LINK*

Darrell Feltmate

>Thanks Carole. Sharing is one of the great parts of turning. I keep thinking of putting a gap stop on a hook. It might be worth it. I put a new video on the site for downloading. It uses the Oland tools to turn an 11" mushroom.


Around the Woods