Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Hand wheel for Delta Lathe

Posts

Hand wheel for Delta Lathe

#1

Hand wheel for Delta Lathe

Lester Gillett

>I have a Delta 14/40 Lathe and the hand wheel on the outboard head

stock is so small its hard to turn by hand. Has any one add a larger

wheel to your lathe? Was thinking about a belt pully so i could add

may be a small motor to turn it slow to finish my turning. I know

George has add one to his lathe and it seems to work good.

Lester

Re: Hand wheel for Delta Lathe

#2

Turn one.

Bob Fawcett

>

Re: Hand wheel for Delta Lathe

#3

Re: Hand wheel for Delta Lathe

Pete LaBelle

>Check Grizzley's stuff. I replaced a plastic tail stock handwheel with one of their cast iron units. You will probably have to drill/bore it out to fit your shaft though. If you can't find the one you want there, check out Reid Supply Company (AKA Reid Tool).

Re: Hand wheel for Delta Lathe

#4

Re: Hand wheel for Delta Lathe

Al Kapocius

>Plastic handwheel on mine is cracked but useable (so far). Quill has a short transverse roll pin that the handwheel keys on. One of these days I'll find some tubing to fit over the threads and whittle or hacksaw out a slot. Then I can slip the tubing inside a new handwheel.

Al Kapocius