Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Jet Outboard Tool Rest

Posts

Jet Outboard Tool Rest

#1

Jet Outboard Tool Rest

Roger D. Coates

>I was at the Woodcraft store in Mobile, AL this morning for the Azalea Woodturners meeting and saw Jet has a new, stand alone, tool rest for outboard turning. It's three legged, cast iron, and seemed to weigh about 75lbs. Big footprint, but stable. The price was $349. Might be a viable option to the outboard attachment available for my DVR XP.

Roger in Ocean Springs, MS


img

Re: Jet Outboard Tool Rest

#2

Re: Jet Outboard Tool Rest

Ron McKinley

>I believe the outboard attachment for the DVR XP is about $50 cheaper.......Ron

Re: Jet Outboard Tool Rest

#3

Steven Antonucci

I did this for my Nova...

steve antonucci

>Blackpipe for the crossbar, filled with cement to dampen vibration, wooden plugs to keep it from pouring out.

I turned down the blackpipe in my chuck with a file and 50G sandpaper so it fit the banjo.

The stand on the left is a few two by pieces with a hole to support the end. Works way better than you'd probably guess.

Steve


img

Re: Jet Outboard Tool Rest

#4

Steve, that is what I did as a rest

Don Henthorn

>for my old Blount lathe. Turned a lot of fifteen inch dished stool seats with that rest.

Re: Jet Outboard Tool Rest

#5

I think it's way over priced!

Phil Joines Krum, TX

>

Re: Jet Outboard Tool Rest

#6

Re: Jet Outboard Tool Rest

wilbur

>I thought the outboard attachment for the DVR XP attached directly to the lathe, so that there is a limit on how thick a piece it could be used for. Am I wrong on this?

Re: Jet Outboard Tool Rest

#7

Re: Jet Outboard Tool Rest

Carole Valentine

>You are correct. It is basically only good for platters or very shallow bowls. Mine holds my chuck key, my spur and live centers, my calipers, my knockout bar and a few other sundries as well. In effect a very expensive tool rack.


img