Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

step center

Posts

step center

#1

step center

peter kolb

>Hi, What is the proper procedure in using the

step center in very hard wood? I have been

center punching the end of the wood, insert

the center in the lathe and mounting the wood

and using the tail stock with a live center.

Advancing the tail stock quill to engage the

teeth of the step center. On a Nova 3000,

I have noticed that the spindle bearing closest

to the step center getting warm, not hot but

warm. Should I be setting the center with a

mallet before mounting? Thanks for your help

peter in south central nj

Re: step center

#2

JL

Re: step center

JL

>Do you mean a Sorby Steb center? For spindle work, I typically set my four prong center with a wooden mallet. I haven't really had to do that with my Steb center. I just use the center punch on both ends and mount the spindle. I use gentle pressure from the tailstock until the teeth of the Steb center just engage and sink a little into the wood. As far as your bearings getting warm, that's a question for the Nova owners. I'd figure on some heating though.

Re: step center

#3

Re: step center

Hooligan

>Because they do take a bit more pressure, you are going to get a little bit more heat. I noticed the same thing. I notice the same thing with the safe drive cup center, too.

Re: step center

#4

Bearing heat

Dave Belser

>I've had my Nova DVR XP for close to a year now. I don't remember where I read it (online or from Teknatool) but this is what I remember about the bearings. The bearings can use a little run in period and will be warmer before they are "run in". The recommendation was to run the lathe with no load at 1500 RPM or more for an hour or three. During this time you can expect the headstock casting to get quite warm near the where the spindle protrudes. You may even have some oil leak out a bit. During normal use, particularly at higher speeds the headstock casting will get quite warm to the touch - but it should not be too hot to touch! If it is you have a bearing problem. I would expect that it would also be noisy if it was creating this much heat.

I did the run in procedure on my lathe and it did indeed get rather warm, I also notice that the casting will heat up when I run it at higher speeds for a long time. In particular, when I make a number of small tops, I'm not really asking the bearings to do much but run fast for awhile - I.E. not much of a load.

If you have any concerns about your lathe contact Teknatool support in the US - The guys name is Tim Giest I think. The contact info should be in the manuals, I can look it up and send it if you can't find it. Their support is great, in my opinion (a satisfied customer).

- Dave

Re: step center

#5

Re: Bearing heat

Ron McKinley

>Dave: I've had my DVR XP for about 3 months but there was no mention of a "run-in" procedure in the instructions........Ron

Re: step center

#6

Re: Bearing heat

Dave Belser

>Ron, as I said, I don't remember exactly where I read it. It may have been on the CD they included buried in with other FAQ's or it may have been from a Teknatool person on the MSN Nova owners group. At the time, the Teknatool site had the stuf on the CD on it also so I may have read it there.

- Dave

Re: step center

#7

Re: Bearing heat

Ron McKinley

>Thanks Dave. Guess it's too late for me to run-in the bearings........Ron