Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Got er runnin

Posts

Got er runnin

#1

Got er runnin

Larry Clinton in Frankfort, Indiana

>We finished converting the Powermatic 90 ex school lathe to 220 Single phase. Also completed the cleaning, repainting etc. SWMBO told me to go ahead and buy the new chuck now. So I have a live center and a Stronghold chuck package from Woodcraft, delivery due tomorrow. Spun her up last night finished adjusting the Reeves drive today. Conversion to single phase was quite simple, and a new Leeson 1 hp motor was only $161 delivered. Got an awful lot to learn about turning, but at least the material is cheap in this area (free). Hope I can still find time to finish up some flat work projects :~)


img

Re: Got er runnin

#2

Re: Got er runnin - Too pretty to use !

Ray Carson - New Jersey

>Very, very nice Larry. Looks like it's "out of the box."

Re: Got er runnin

#3

Re: Got er runnin

George Van

>Look good Larry. I�ve got a PM45 in the shop that I can�t bring myself to sell, wish is was a 90. You had best finish up those flatwork projects soon or I will have to give you my storage ideas for projects not completed!

Re: Got er runnin

#4

Re: Got er runnin Sigh!

Ruth Niles

>I remember when my General looked that nice and clean and I promised myself I was going to really try to keep him looking spiffy. HA! He's got chips in his paint, knicks on his ways, little gobs of chips stuck to his sides where CA dripped and a few taped notes on his right leg. I still love him just the same.

Nice lathe, Larry.