Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Swan Neck Shank

Posts

Swan Neck Shank

#1

Swan Neck Shank

Paul Coppinger

>I just completed hollowing a 6" diameter oak burl sphere thru a 3/8" hole. I used the Kelton Mini-hollowing tools (5/16" shank) that removed everything but the last 3/4" of the side wall. To keep from opening the hole anymore, I made a slightly larger swan neck tool from 5/16" mild steel with a 3/16" HSS cutter. The cutter was from Enco, Made in China, about 3" long that I cut in half and then rounded the corners of the back half before shaping the cutting end. I drilled a hole in the end of the 5/16" rod to hold with C.A. glue after shaping the swan neck shank with heat. The tool shape reached the sides adequately allowing the final sides walls to be less than 1/4", but if I got a catch, the mild steel shank bent requiring straightening several times on my anvil. Should I have used O1 tool steel and tempered to about 400-430 degrees? If not, what could have made a less-bentable shank to reach thru the 5/16" hole?

Thanks

Paul Coppinger

Re: Swan Neck Shank

#2

Re: Hey, Paul!!! I hear ya.

Allen Neighbors

>Paul, I've made a few tools over the last two and a half years. I don't think you should use a stronger metal for the shank, because it's better to bend the tool, than to break through the side of a piece. :o) I think you might find the answer to your problem is that you may be going too large with the cutter for the size of shank you have.

I have a 3/8 hot rolled steel shaft, that I've never bent. And I think the reason for that is the size of cutter I use in it. 1/8".

The farther you get from the toolrest, the smaller the cutter needs to be... in most cases, that is. I think this is especially true when your tool shaft is only 5/16" I would try a 1/8" cutter in it, if I were you. Or at the least, you might grind down the sides of your cutter, so that you don't have more than 1/8" of width on the business end. (Sometimes I bend my 1/8" cutter, because I keep too much of it sticking out, but the catches are way fewer.)

It's difficult for me to get "smooth innards" with this size cutter, but I really have a strong familial tremor.

Hope this helps you a little.

Allen


img

Re: Swan Neck Shank

#3

Re: Closer view: 

Allen Neighbors

>


img

Re: Swan Neck Shank

#4

Re: Hey, Paul!!! I hear ya.

Paul Coppinger

>Allen,

Although I shaped the 3/16" cutter to a typical elliptical shape, I like your suggestion about using the 1/8" cutter. And keeping soft steel as a "fuse" makes good sense also. I will try the smaller cutter next.

Thanks,

PAC