Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Sorby Fingernail Profiler??

Posts

Sorby Fingernail Profiler??

#1

Sorby Fingernail Profiler??

gtwilkins

>Gooday All,

Doe's any-one out there in the ether use the Sorby Profiler?

I am looking at it, as I don't want to have to pull my grinding set up apart to fit the Wolverine type system.

Any observations ,comments gratefully accepted! Bye the bye the Vicmark is a dream, pics soon.

Thank You, Trevor

Re: Sorby Fingernail Profiler??

#2

Re: Sorby Fingernail Profiler??

Cyril Griesbach

>Trevor,

I have not used the Sorby but their web site has a video on it. I don't think it's worth the wait for a dial-up connection but the download isn't bad with high speed.

Looks like it works much along the lines of the Tormek (and now Jet) systems except it uses the dry wheels of a standard grinder and sets up only on one wheel. At least with my Wolverine system I can either of the grits on my wheels.

Cyril

Re: Sorby Fingernail Profiler??

#3

Richard Allen

Re: Sorby Fingernail Profiler??

Richard Allen

>That is the fingernail jig I have used for 9 years. I have used the Oneway jig and I prefer the Sorby. The thing I like is that you can let go of the tool and the tool will fall away from the grinding wheel. I also like that once you have the base fixed and the angle of the tool set up you just need to fix the distance the tool extends beyond the jig.

As the wheel gets smaller the angle on the bevel angle will change. This is a slow process that will take many YEARS. When you get a new 8" wheel to replace your old 8" wheel that has worn down 6" you will need to re-profile your gouges.

One of the "issues" with a non-Oneway jig is that you are most likely to find the Oneway jig at other locations. So when you take your gouge to a woodturning friends house sharpening will change the profile.

Re: Sorby Fingernail Profiler??

#4

Re: Sorby Fingernail Profiler?? *LINK*

Darrell Feltmate

>I just use my home made jig. if I need to or want to, it is easy to make a holder to duplicate the Sorby or another profile. Check out the sharpening section on my site.


Around the Woods

Re: Sorby Fingernail Profiler??

#5

Leo Van Der Loo

Re: Sorby Fingernail Profiler??

Leo Van Der Loo

>Trevor I built a similar setup, several years ago, it works fine, but is a pain in the b??? any other time, if you want to grind on that same wheel.

I have bought a 10" grinder and build a Wolverine like setup for that one, much easier and flexible, if I had to do it again, that's the way I would go now, just my way of looking at it.

Have fun and take care

Leo Van Der Loo


img

Re: Sorby Fingernail Profiler??

#6

MHO...

Peter Teubel

>I've used it and don't like it at all. The wolverine is worth the time it takes to intall it.