Re: Robust lathe arrives V
Ed Moore
>The crew wouldn't leave until they had the lathe on the floor and in position for me. The tip I gave them was well worth it.
I plugged the lathe in and turned it on. Smooooooth!
Then I checked the tailstock and the alignment. Essentially NO PLAY in the tailstock spindle. And the alignment was dead on.
Now if we can just do something about the stupid grin on my face. ;^D
I applaud Brent English of Robust Tools LLC for making such a fine product and being so easy to work with.
My initial reaction to the lathe was funny. I am used to a 10" swing lathe and thought that the Robust bed was too low. Then I put my elbow up to the spindle and the light-bulb went on. It was exactly at the height I had requested.
Now I must complete preparation for the ornament demo I am doing at Blue Ridge Woodturners tomorrow evening. I am doing half and Bob Vaughan is doing the other half. Had the lathe arrived tomorrow there would have been a problem - and I threatened to take a long stick to Bart Castleberry. Bob Vaughan described it as leaving a bride on the wedding night, which was an interesting analogy.
My thought as I slow down a little is that for many reasons I am a lucky man.
Ed
