Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Problem with lathe

Posts

Problem with lathe

#1

Problem with lathe

Bill Crommett

>Does someone out there in the twist and turn land have any experience with variable speed General 260 lathe ? I have been trying to round off a 12 in hard maple log that is bone dry. This neccesitates moving slowly to keep from bouncing all over the room. Because of the slow RPM I get a few catches and an occasional stall. The usual treatment for a stall is to unplug the cord for a few minutes, sweep up the shavings, plug it back in and GO. The last time it didn't work. The switch clicks and the other outlet on the same circuit is functioning. No motor activity. What do I try next ??

Re: Problem with lathe

#2

Keith Tompkins

Re: Problem with lathe

Keith Tompkins

>Hi Bill, low rpm and heavy load may cause the motor to overheat. Be sure you are on the lowest speed pulley, this will help in the future. You mentioned you keep your belt on the loose side...a belt that slips and then suddenly grabs will possibly trigger a stall. I would keep that belt tight when turning large, heavy pieces. If all else fails, your converter may be flashing a fault code "flt" after you reconnect the lathe. the owner's manual will list the codes and the remedy to get you going again. Let me know if I can help.

Re: Problem with lathe

#3

Re: Problem with lathe

Bill Crommett

>Keith: Part of the problem is that the converter codes are all off ,dead , dark, so I will have to go find the manual. Thanks. Bill

Re: Problem with lathe

#4

Re: Problem with lathe

Hooligan

>Bill, I think that the 260 has a reset button on the backside of the motor. Should be towards the tailstock end, on the lower side, away from you..... I am almost sure that the 260 does.

Re: Problem with lathe

#5

Re: Problem with lathe

Harvey Brooks, Victoria, BC

>Bill,

If its not a EVS lathe, there may be a reset right on the switch, On my old General 160, there was a built in breaker in the switch. To reset it, push the switch down, past the off position and it will reset.

Harvey

Re: Problem with lathe

#6

Re: Problem with lathe

adrien

>Sounds like you're not getting any power at all to the lathe if the code lights are off..

Re: Problem with lathe

#7

Keith Tompkins

Re: Problem with lathe

Keith Tompkins

>I was thinking that as well Adrien. Time to make sure both legs of the 220 V circuit are live. It's possible a circuit breaker tripped.

Re: Problem with lathe

#8

Re: Problem with lathe

Bill Crommett

>The power is good up to the point of the male end of the power cord. I can find no reset button on the motor.

I have located to Avitar (sp) booklet for the installation, but I have not been able to find the directions for trouble shooting.

At one time I bought a new switch, but found that all the old one needed was a good blow-job and it has worked well ever since, but then the indicator LEDs were all working.