Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Pen kit disassembly tools?

Posts

Pen kit disassembly tools?

#1

Pen kit disassembly tools?

Bill Turpin in WNC mountains

>Do these really work? Does anybody make one that will fit all the common tube sizes? They seem rather expensive. Are they worth it?

We recently purchased 17 identical kits from the the same vendor. Two different shipments a week apart. However, the internals were of three different total lengths. Mighty tough when all the pieces-parts are mixed together and you discover this when assembling the turned wood. At least four of them have the ink sticking out when retracted. The pens were made for a memorial service this past weekend, did not discover until putting them together a couple of hours before the service. The wood was from a tree that the deceased had planted.

The kits were $4.75 click pens from PSI. The blanks were cut in a jig, were the same length, and end milled identically. The two shipments of the kits had the same length brass tubes. Not every tube was checked. I will not mix kits in thr future!!!!

Bill Turpin in WNC mountains

Re: Pen kit disassembly tools?

#2

Re: Pen kit disassembly tools? *LINK*

Russ Babbitt Jr.

>Most pen turners will say save you money and get a set of punches from Harbor Freight. Check out the link below to find out more about pens.....


International Association of Penturners

Re: Pen kit disassembly tools?

#3

Re: Pen kit disassembly tools?

eaglesc

>Which kits did you get?

MAny use different length tubes for top and bottom.

I use PSI kits and any time there is an issue with the refill sticking out too far I can trace it back to (in my case) operator error.

Sorry to hear about your results

Re: Pen kit disassembly tools?

#4

Re: Pen kit disassembly tools?

Bill Turpin in WNC mountains

>PSI power click pen. The tubes are the same length, the critical dimension is the total length. The left over parts mic at different lengths. What hurt so bad was the fact of the completion deadline and the scarcity of some VERY special wood! I can turn some washers for the nib end, but that could not be done before the service.

Bill in WNC mountains

Re: Pen kit disassembly tools?

#5

Re: Pen kit disassembly tools?

Bill Turpin in WNC mountains

>I had an appropiate punch, but how do you hold a finished blank without ruining it?

Bill