Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Spiral Bowl

Posts

Spiral Bowl

#1

Spiral Bowl

Lester Gillett

>I am doing a demo for our turning club and i am going to do a spiral

bow i watched on wood working channel. The trouble i am having is

cutting the blank on the bansaw. I have a 12" Sears saw with a 1/2"

4tpi blade. I can't seem to stay on the line when cutting the spiral.

I have tried tighten the blade and setting the guides to no luck. The

wood is Mahogany 1 3/4 thick by 10"round. Help please as i am to do

the demo this month.

Lester

Re: Spiral Bowl

#2

Re: Spiral Bowl

Bill Hale / Woodspinner

>? Blade size ?

That 1/2 x 4 sounds a bit large for what I think you are doing.

Bill

Re: Spiral Bowl

#3

Re: Spiral Bowl

Russ Babbitt Jr.

>Try a smaller blade, like 3/8, the smaller blade will make it easier to cut a smaller radius.

Re: Spiral Bowl

#4

Keith Tompkins

Re: Spiral Bowl

Keith Tompkins

>HI Lester, try this. First, set your guides. It's important that the blade is centered on the wheels to start. Then, adjust the rear rollers, top and bottom. They should barely touch the back of the blade while rotating the wheels by hand, no load on the blade.Next, set the side guides. TAke a look at the guides...if worn, they can be reversed or re-ground flat. Make sure the guides are not pushing the blade unevenly to one side,and they are situated back far enough that they don't contact the blade's teeth. For conventional guides or coolblocks, a piece of thin paper inserted between the guides and the blade acts as a clearance guage. Loosten both guide set-screws, apply equal finger pressure to both, and tighten the guides. This simplifies the operation. Set both upper and lower guides in the same manner.

Next, mark a straight line on a piece of scrap wood, and saw along the line. If you have to hold the wood at an angle to the saw table while cutting, the blade is pulling to the side instead of cutting straight. If the blade is new, you can compensate for this (or take it back for exchange) , if old, replace it. At this point you can be pretty sure the blade is the problem, NOT the guide adjustment.

I don't know the radius of the spiral you are cutting, so make sure a 1/2" blade can make the curve freely without binding in the cut. You may have to switch to a thinner blade, requiring a new set-up of the guides.

Last, use the back edge of the blade as a guide....you can actually pivot the wood against the back edge, which gives much better control than just cutting freehand. Hope this helps, Keith

Re: Spiral Bowl

#5

Re: Spiral Bowl

Lester Gillett

>Thanks guys for the info. I though i might have to wide of a blade.

Will try a 3/8 blade and see if that helps. I am going to use a 3"

face plate and spiral out from the edge of the 3" to the out side edge. I have cut up a couple of oak blanks but they seem to be to

corse of a wood so that is why i am going with Mahogany.

Lester