Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Replacement Bearings for Angle Driil

Posts

Replacement Bearings for Angle Driil

#1

George Balock

Replacement Bearings for Angle Driil

George Balock

>I have a Milwaukee Angle Drill that I use for power sanding just like everybody around here. Today one of the bearings went bad, just like everybody elses around here. I've killed myself looking through the archives trying to find information on the replacements, but have come up empty. Also, How do you get the old bearing off?

Thanks,

George

Re: Replacement Bearings for Angle Driil

#2

Here tis

TDaniel

>George, you can cut the old bearing off with a Dremel or with the corner of your grinding wheel. Cut the outer race first and get rid of it, then carefully cut the inner race so that you do not damage the shaft. A little nic won't hurt but don't get too aggressive. I cut the inner race on two sides and then twist off the halves with a pair of vise grip pliers. There are several choices for the bearing. The original one is likely a shielded bearing that is made in China and is a very low quality bearing. Enco sells a slightly better bearing or rather an equal bearing with a better dust seal. It is called a sealed or double sealed bearing. I prefer to spend a few dollars more and get a bearing that is made in Japan and is double sealed. It is a Koyo bearing, part no. EE 1 1/2 2RSM3GSR. I can't tell you how long this one will last because I have never burned one out.

TD

Re: Replacement Bearings for Angle Driil

#3

Alternate approach

Bob Fawcett

>This would be heresy to some.

Harbor freight sells a near copy for $39. The WEB site shows it on sale at the moment for $29.

I can't say how long the bearings will last, as I have only had mine for a few weeks. It works well for sanding.

They call it a "close quarters" drill. At $29, it is almost as cheap as good bearings.