Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Why?

Posts

Why?

#1

Why?

Carole Valentine

>Are there only 14 participants in the turning wood exchange? Come on folks...Jason offered to do this so let's make it worth his time.

Re: Why?

#2

email problem? (not a complaint!)

Dave Belser

>I don't know about anybody else but I've sent email twice and I'm still not on the list! This is not a complaint, I just don't want to miss the bus and/or party :)

Here is the email I sent last night around 8 EST:

Hi Jason, either I'm no good at following directions or you didn't get

my email!

I'm in, my address (which I left out on my first email) is:

David Belser

34 River Road

Penacook NH, 03303

For Blanks, I'll be sending bowl sized blank of figured Ash and a small blank (pen/finial/top etc.) from a Smoke Tree

- Dave

Re: Why?

#3

Re: Why?

Hooligan

>I'd love to, but I am so far behind on things that it is unbelieveable. Yet...here I sit.....between classes, on the boards. Go figure ;)

Re: Why?

#4

Would if I could...

Jay Kilpatrick in TX

>Carole,

I just got back into town a little while ago, and I'm heading back out tomorrow. I'll miss the entire timeframe. I've participated in the past, but am not available for this one. Good enough excuse?

Thanks,

~Jay... remember "remove" for email.

Re: Why?

#5

Re: Why?

Gil Jones

>Carole, I could be a tad dense (nah), or just old (yup), but if you had not just mentioned a wood exchange I would never have known of it. Where is it listed? When I visit WC, I come in on the home page, and go straight to 'turning' and I do not see 'wood exchange' mentioned in the left hand column.

Gil

Re: Why?

#6

Re: Why?

Carole Valentine

>Gil,

The thread is titled "Turning Blank Exchange". You can email Jason Clark. I think the deadline for signing up is tomorrow.

Re: Why?

#7

Re: Why?

Gil Jones

>Carole, thanks, done.

Re: Why?

#8

I'm in.

Ron McKinley

>I'm in now. I completely missed that thread. Thanks.......Ron