Open Segmented Turning Question
Ron in Drums PA
>I'm trying to figure out a good way to space the "holes" evenly.
Any suggestions would be helpful.
Does anyone know of a book or a link on open segmented turning?
Thanks!
Knowledge You Can Build On — Est. 1998
Open Segmented Turning Question
Ron in Drums PA
>I'm trying to figure out a good way to space the "holes" evenly.
Any suggestions would be helpful.
Does anyone know of a book or a link on open segmented turning?
Thanks!
Re: Open Segmented Turning Question *LINK*
Bill Stehman
>Ron,
This article might get you going but there are many ways set up. Bill Smith has an excellent book out.
Article
Re: Open Segmented Turning Question
Russ Babbitt Jr.
>http://www.woodturnerscatalog.com/cgi-bin/shopper?preadd=action&key=154-0090
http://www.woodturnerscatalog.com/cgi-bin/shopper?search=action&keywords=segeasy-plate
Thanks Bill & Russ
Ron in Drums PA
>Just what I was looking for.
Re: Open Segmented Turning Question *LINK*
Anthony Y
>
link
Re: Open Segmented Turning Question
Ron in Drums PA
>Thanks Anthony, I was thinking of making my own jig, looks like it can be done.
Re: Open Segmented Turning Question
Denis L
>IO built my own jig from Bill Smith's book...Excellent reading to get you started....Denis