Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Woodfast lathe motor

Posts

Woodfast lathe motor

#1

Woodfast lathe motor

Greg Purcell

>I've used this particular lathe for the past 16 years without a hitch. While using a center-saver system, it just stopped. Yes, the motor was quite hot and I had been turning for a number of hours, but I didn't smell anything burning? It has a 1-1/2 HP, with a DC converter. Anyone with a Woodfast know if there's a "reset" somewhere or am I looking at a new motor? I can't really complain after 16 years but, if there's a fix I'd sure appreciate your advice.

Greg

Re: Woodfast lathe motor

#2

Re: I know the controller is........

Jamie Donaldson

>.....mounted in the tailstock side enclosure on mine, but haven't seen it in years. There may be a reset but you will have to remove the whole controller to find out.

Re: Woodfast lathe motor

#3

Re: Woodfast lathe motor

Russell L. Babbitt Jr.

>You might give the support folks at Craft Supply a call. They were Woodfast vendors and assembled the drive systems. Nice folks there.

Re: Woodfast lathe motor

#4

Re: Woodfast lathe motor

Dinyar Chavda

>On my Woodfast controller box, there are 2 little black cyinders on the outside that house a fuse each. I have had one blow, and you might want to check those first---se picture below.

Failing that, I'd call the tech support guys at Craft Supplies. They have been incredibly knowledgeable and helpful, even to a technical moron like me.


img