Torchin', tappin', turnin'
Edward Damewood, Northern Alabama
>I'm a rookie turner at best, but I've successfully made some tool handles with improvised ferrules. I have used copper pipe and even some 1" steel tubing, though the latter was a bit of overkill. That steel ferrule does have a nice robust look on the oversized turning tool handle it's on, though.
I made sure the stock was good and dry and sized for an interference fit in the ferrule, put the ferrule down on a scrap 2x4, heated the ferrule with a MAPP torch*, and tapped the handle down into it. The 2x4 had a hole in it just the right size that it would stop the ferrule**, but allow the handle stock to go down into it -- so as to firmly seat the ferrule. Come to think of it, I even put a slight taper on the stock so as to encourage the ferrule to stay seated over time. Anyhow, it's tight as a tick, and I expect it will stay that way. Polished it up with a little sandpaper, and Bob's my uncle.
*Yeah, that scorched the 2x4, but what the heck.
**Come to think of it, there's a piece of ferrule material embedded in it for just the right size and strength needed.