Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Pen mandaral run out

Posts

Pen mandaral run out

#1

Pen mandaral run out

alan womack

>I just replaced the rod in my manderal (woodcraft MT2) shaft. I was getting some difference at the nib end of my pens.

What is an acceptable run out at the nib end of a pen manderal?

The new one measures about .003+

Alan

Re: Pen mandaral run out

#2

Re: Pen mandaral run out

Ron in Drums PA

>- - You can bow the mandrel by tightening it too much and cause a misalignment with the metal parts to the wood parts.

- - Sometimes I will rotate the blank on the mandrel 180 degrees, seems to help.

- - Mic up the bushings and the nib, are they the same size? You would be surprised to find out they may not be the same dimension.

- - Is your tailstock aligned with the headstock?

- - Did you tighten the live center into the mandrel too much?

Re: Pen mandaral run out

#3

Re: Pen mandaral run out

eaglesc

>Another thing that is overlooked is are the ends of the bushings or do you have any CA buildup?

IS the inside of the Morse taper clean?

any crud or rust on the mandrel?

Russ Fairfield has a "tune up" section on his site for pen turnig stuff.

It is a great read.