Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

last picture of inertia sander

Posts

last picture of inertia sander

#1

last picture of inertia sander 

Bob Elliott

>


img

Re: last picture of inertia sander

#2

Re: last picture of inertia sander

Jennifer@Indy.USA

>Bob, this looks like a serious upgrade from the original Sorby model I have. I've never used it much becasue the darn thing just doesn't spin!

Nice job on your design.

Jen

Re: last picture of inertia sander

#3

Re: last picture of inertia sander

Bob Elliott

>Thanks, Jen.

For me it was a serious upgrade because I was too cheap to spend the $40-$50 for a manufactured unit. I have about $7 in bearings and collars (incl. freight) and less than a dollar for the plastic tubing. Had to buy a 1/4" x 20 die for about $3.70. The drill rod was a gift.

I bought enough to make 5 units and sold off 2 of the collar / bearing kits to turning buddies.

Used the sander for a little bit this afternoon and it really works!

Re: last picture of inertia sander

#4

Re: last picture of inertia sander

Mike Brazeau

>I'm with you Jennifer. I bought the Sorby in my earlier days and will not even try to sell it at a greatly reduced price. Wouldn't want to inflict it on anyone else. Have to look at it and see if a bearing upgrade for the bronze bushing is possible.

Mike

Re: last picture of inertia sander

#5

article in Woodturning Design Fall 2006

Bob Elliott

>Jennifer and Mike,

You two need to read the article in Woodturning Design Fall 2006 (page 79) by Guy Marsden. In it he takes the Robert Sorby Sandmaster and creates a new swivel block for bearings, a hardwood disk w/ foam and velcro and adapts it all to the existing handle.

I thought about making the hardwood disk w/ foam and velcro, but decided not to re-invent that wheel.