Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

home made inertia sander

Posts

home made inertia sander

#1

home made inertia sander

Bob Elliott

>This project was inspired by a recent article in Woodturning Design. The handle started out roughly 3/4" square. A 5/16" hole was drilled at slight angle and then the opposing 5/8" counter bores to accept the bearings. After drilling was complete, I placed it between centers to round the lower handle to accept the 3/4" plastic tubing. Finished handle length is 8 1/2".

The sanding pad is 3" and can easily be replaced with a 2". I removed the original hex shaped shaft (unscrewed it). Then I cut / threaded my own 1/4" piece of drill rod.

There are (2) 1/4" I.D. sealed bearings and (2) 1/4" I.D. collars which came from Enco (could not find the bearings in local hardware stores).


img

Re: home made inertia sander

#2

Re: home made inertia sander

Bob Fawcett

>Looks great Bob.

Did you make the pad or extract it from a previous unit?

Re: home made inertia sander

#3

Re: home made inertia sander *LINK*

Bob Elliott

>Thanks Bob.

I extracted the pad from another unit. Bought the pad from Steve Worcester @ turningwood.com. I think the pads (1", 2" & 3")

are also available from Packard. The pads are made in Australia and as far as I know they are the only ones that the shaft can be removed. The picture below shows the pad with a hex shaft. That shaft screws into the base of the pad (1/4" x 20 tpi).

The neat thing about these pads is that I can screw them back onto the hex shaft and and go back to power sanding with a drill.


img

turningwood,com

Re: home made inertia sander

#4

Re: home made inertia sander

Bob Fawcett

>Thanks Bob.

I have a couple of the ones that Craft Supply sells, but there is not removable shaft. The shaft is attached in some molded plastic.

They work well in a drill, but may not work in a setup like yours, I don't think the shaft is long enough.

Re: home made inertia sander

#5

Re: home made inertia sander

Barry Irby

>Bob, I have been wanting to make some of these. A question. Would it work if you unscrewed the shaft and screwed in a piece of All Thread rod? Then you could use nuts to lock it in place. Might have to use two nuts on each side to lock them into place.

Re: home made inertia sander

#6

Re: home made inertia sander

Bob Elliott

>Barry,

Come on...that would be the easy way out!

I originally tried a couple of high quality 1/4" bolts with a long unthreaded shoulder only to find that the 1/4" hole in the bearing was too big for the threads or the shoulder. That's why I used the drill rod which is a true 1/4".

When I assembled the sander, I had to press the rod into the bearings, it was that snug. Used a small clamp.

Just walked out to the shop and checked 1/4" all thread. Does not fit tight in the bearing. But I guess you could double nut either side of the 2 bearings and tension against the inner races to get the bearings to spin. Still, there may be a little play which would result in some vibration. I'd say give it a try!