Re: Holdfast vacuum chuck *LINK*
Mark Mandell - Gone Round In Jersey
>Lynne,
I looked at their set-up at the AAW in KY. The rig that I looked at in Packard's booth was listed as 15" hg. max which is OK for larger stuff and platters, but not for smaller items with less cross sectional area. Note also that the induced CFM flow through the venturi is not all that much, so the system will not tolerate leaks or porous wood.
Add to that the cost to run an air compressor motor as compared to a real vacuum pump, and this doesn't look like much of a deal. You can contact the Surplus Center at the link and do a search for vacuum pumps as they have very good Gast 5cfm vacuum pumps for $90 if you have 220v available in your shop. You can also contact Bernie at hydrolicparts.com as he rebuilds Robinair pumps and had some 115v 6cfm vacuum pumps for about $175 delivered which is a great deal. [Usual disclaimer here]
Surplus Center