Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

question about finial design

Posts

question about finial design

#1

question about finial design

bernie feinerman

>I am finishing a walnutlidded bowl I started years ago which is about 6 1/2" diameter and 2 1/4"high. The lid is about 1/4" thick. Are there recommendations for a knob/finial for the lid besides using a peice of walnut or maple and making what "looks good"?

Re: question about finial design

#2

Re: question about finial design

Bill Hale / Woodspinner

>Need a pic on this one.

Bill

Re: question about finial design

#3

Re: question about finial design

bernie feinerman

>The bowl and lid were started 10-20 years ago when I knew less than I know now (which is still not much). The bowl itself is 7 1/4" diameter by 2" high and is slightly warped. The unfinished lid is 3/8" thick x 7 3/8" high. I still have to cut out the dog, clean up the cutouts, fill the cutouts with colored epoxy, and finish the project.

I thought that adding a knob/finial would be better than leaving the lid flat and was curious if there were any guidelines for knob or finial designs.

(the reddish casts are from my not using Irfanview properly)


img

Re: question about finial design

#4

Re: question about finial design NM 

bernie feinerman

>


img