Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

saving sandpaper

Posts

saving sandpaper

#1

saving sandpaper

john lucas

>When I sand over sanding sealer or sometimes oily woods it often clogs the sanpaper quickly. I find a file card used for cleaning files will get rid of the clog and renew the sandpaper. It doesn't totally renew it because it wears it away a little. You can reuse the paper several times before having to toss it.


img

Re: saving sandpaper

#2

Re: saving sandpaper

Barry Turner

>One of those stiff, steel-bristle brushes that you use for removing loose flaking paint on a house before re-painting works well, too.

Re: saving sandpaper

#3

I do the same...

Peter Teubel

>...but I mount the file card on the lathe somewhere with magnets so I can just touch the spinning sanding disc to the card to clean it off.

Re: saving sandpaper

#4

Re: saving sandpaper

Bill Hale / Woodspinner

>Many years back I was at a turning seminar and the demonstrator made a comment about sandpaper that I have never forgotten.

" Treat sandpaper like someone else was paying for it."

I keep a small trash can next to the lathe and never try to stretch usage. It works a lot better.

Good turning and be safe

Bill in Dolores, Colorado

Re: saving sandpaper

#5

Re: saving sandpaper

John Lucas

>I would agree in most cases but in cases like this it's silly to throw away a disc after one pass over the wood.

Re: saving sandpaper

#6

Re: saving sandpaper

eliot

>I use one of those rubber blocks designed to refresh sanding belts, etc. It works especially well on 3M power sanding disks. Before each power sanding use, I just hold it to the spinning disk for a few moments. Refreshing the sanding disks this way is a good idea and is not like wasting your time with worn out sandpaper.