Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Looking for a smaller tool rest *LINK*

Posts

Looking for a smaller tool rest *LINK*

#1

Looking for a smaller tool rest *LINK*

Samuel Brooks

>I have the Jet JWL-1442VSK wood lathe and I have just recently started turning pens. I would like to get a smaller tool rest for this lathe. I cannot get the tool rest closer then about 1" from the pen. I am looking for recommendations.

Thanks in advance.

Sam Brooks


My Jet Lathe

Re: Looking for a smaller tool rest *LINK*

#2

Re: Looking for a smaller tool rest *LINK*

Bill Turpin in WNC mountains

>Best Wood Tools T-bar Modular Tool Rest is the answer. They will even custom make them. I have a 4", 2" and a offset (3" x 1") one. No extra charge for custom service. Their hand tightening drill chuck is a wonderful tool also. Just a satisfied customer, no connection.

Bill in WNC mountains


BW Tools

Re: Looking for a smaller tool rest *LINK*

#3

Re: Looking for a smaller tool rest

john lucas

>I have the 9" bar that's offset from Bestwood tools. It's my favorite tool rest. I can get my hands around it for stabilizing pens and ornament finials. The offset lets me reach inside bowls so well that I don't use my curved rest very much.

Re: Looking for a smaller tool rest *LINK*

#4

Re: Looking for a smaller tool rest

eaglesc

>If it is because og the length of the tool rest that prohibits you from getting close enough,get another OEM tool rest and cut it down to fit between the nut and the mandrel.(the same of of each end.

Tool rest for pens don't need to be fancy.

Another suggestion is to get rid of the brass nut.

A good hardware store has lamp parts that are threaded and they are brass.(Most of my mandrels are 1/4x20)

cut one of them short enough if need be and you may be able to get your tool rest closer to the mandrel.

Re: Looking for a smaller tool rest *LINK*

#5

Re: Looking for a smaller tool rest *LINK*

Samuel Brooks

>Thanks for the suggestion.

I was online ordering from Craft Supplies and they also have a tool rest system, so I added it to my existing order. I hope I did not make a mistake. So far I have been impressed with the quality of the products they choose to sell.

Sam


Craft Supplies Tool Rest