Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

hi-speed pneumatic hand piece advice

Posts

hi-speed pneumatic hand piece advice

#1

hi-speed pneumatic hand piece advice

ken chase

>I plan to buy High speed pneumatic handpiece and have a question. Rather than sharing my 15 gallon aircompressor I'm considering buying a three gallon, one h.p. to use with the handpiece. I've never used this kind of handpiece and wonder if it uses so much air the motor will be running a lot. If so the noise will really be annoying. Advice will be appreciated.

Re: hi-speed pneumatic hand piece advice

#2

Re: hi-speed pneumatic hand piece advice

Mac

>I use an air driven handpiece and even with my 60 gallon tank,I find it kicks the compressor on a lot more than I would have thought. And, you are right,it's very annoying when you are in the middle of a delicate cut to have the compressor kick in.My thought would be to move the compressor you have to the farthest point away you can get it,and run a separate hose for the new tool.

Re: hi-speed pneumatic hand piece advice

#3

Re: hi-speed pneumatic hand piece advice

Darryl Hansen

>Ken what is the handpiece. Is it one of the turbo drills or what. The thing that determines whether the compressor will turn on freqently is the CFM rating of the handpiece contrasted with what your toolrequires. If the compressor puts out considerably more than the tool uses and you have a large tank then the cycling will be less. If your tool takes say 1.4 Cfm and your compressor puts out 1.4 at the required pressure without a tank you will have a compressor running continuously. If your CFMs are 1.4 or less you can get away with an silent airbrush compressor which only put out 58 decibles which is rather quiet even if it runs continuously.

Re: hi-speed pneumatic hand piece advice

#4

Re: hi-speed pneumatic hand piece advice

ken chase

>Thanks Darryl:

The catalog for the Powercrafter says the compressor needs to

run 15to 20 CFM at 45 PSI.I better look at the manual of my old Craftsman 15 gallon compressor. I was told an airbrush compressor isn't big enough to run one of these. Too bad...I have a really nice airbrush compressor.

Ken

Re: hi-speed pneumatic hand piece advice

#5

Re: hi-speed pneumatic hand piece advice

Dennis Taylor

>Ken I just purchased a Powercrafter, and it is correct the small air compressor for a airbrush won't work, the manufacture recommends a larger, unit, DeVilbiss Fa70, which sorry to say I just sold one I had for 20.00, but it was loud and ran all the time, I use my shop compressor and the handpiece works nicely, sounds just like the dentist office, I think my tank is 5gal, and it don't run too often, it works out nicely, depends on how much you use it I suppose....Dennis

Re: hi-speed pneumatic hand piece advice

#6

Re: hi-speed pneumatic hand piece advice

ken chase

>Thanks Dennis.

I can't wait to get started. Did you do anything special in your shop to facilitate using the new toy? I'm guessing you would sit while doing this kind of detail work?

Ken