Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Historic 350 Ash Ref:Answers to your questions.

Posts

Historic 350 Ash Ref:Answers to your questions.

#1

Historic 350 Ash Ref:Answers to your questions.

Steve S.

>Location of the logs are in Dolyestown PA area. Reference to Bill Grumbine, I have spoken to Bill and he is aware of the project and was very interested. Except Bill Grumbine is very busy with his new DVD and traveling that he just does not have the time at all to do it.

As far as where you the "Turner" is located I am not that concern. Yes it would be great if the turner was close by. I have spoken to turners in other parts of the country. At this time I am talking with a Trucking company that may donate their service and haul the portion of the log needed to the turner's studio.

So for me it is not so much where the turner is located. Most important is the Turner interested in the project and have experience doing LARGE and mean BIG pieces.

Thank you so much for reading my story. If you have any more questions just let me know.

When the table is done in about 2 to 3 years I will post photos.

Sincerely,

Steven S.

Email: outline@optonline.net

Re: Historic 350 Ash Ref:Answers to your questions.

#2

Re: Historic 350 Ash Ref:Answers to your questions *LINK*

Craig Daymon

>Steve,

Are you a memeber of the Bucks Woodturners? It's a pretty strong group, experience wise and I'm certain there is someone in the group up to the task. Even though Bill Smith typically turns rather small pieces (also typically open segmented), I know he has turned some large pieces as well. Nate Favors rarely turns ANYTHING smaller than 14" (yes, I know you are thinking bigger than that) and is in the area. He's just off 152 from 202 about 1/4 mile headed north. Most of his turnings are done on a OneWay 2436, but I think I recall a bowl lathe back in his shop. Bucks holds their meetings at BCCC, where Mark Sfirri teaches. I wouldn't be surprised if it is possible to open the shop up for a special project like this and I think they have a lathe that could handle it. Mark might as well, though most of his work tends to be long as opposed to wide.

Anyway, there's a substantial number of well-known turners in the area that could likely handle the job and since it is a local tree.

-Craig


Bucks Woodturners Site