Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Questions on making a bowl steady.

Posts

Questions on making a bowl steady.

#1

Questions on making a bowl steady.

Barry Irby

>I have been working on a bowl steady.

Started making one that would accommodate a 16" bowl. (The lathe will swing a 16" bowl) It's too big. Hit the shelf above the lathe.

Rather than cut off the shelf decided to try a smaller one. Made one for 12" bowls, but the "arms" for the rollers hit the shelf.

Clearly should have made a cardboard mock-up.

Questions: How strong do these things have to be? Can the arms be curved like scimitars? I have been putting four wheels on it. Would three be enough? Do the wheels have to be perfectly symmetrical, or can they just touch the bowl most anywhere?

Re: Questions on making a bowl steady.

#2

Re: Questions on making a bowl steady.

ben d.

>Barry''

My expierence is// I have a 14" swing lathe and made one that would accomodate a 13" piece,large vase and since the tool steady rest is about 2" tall I could not move from one to the other without taking the vase off, move tool rest and start over. Not a good thing. My opinion 3 wheels verses 4 is to use 4 because on a large piece there is a lot of distance between wheels and seems to yield more than I liked. I am building me a 4 wheel set up now for this reason. Straight arms verses curved ones ,I personally do not think it would make any difference because you will be setting the wheels in place and locking the arms so the piece will not know any difference.

I turned this vase using it. Finished with crackle paint. Don't like the foot but was request a seperate base to set it on so. 13" x 26"


img

Re: Questions on making a bowl steady.

#3

Re: Questions on making a bowl steady.

Bill Crommett

>Barry: I have made several steadies for different lathes. They have all had just three wheels, which is sufficient unless you are going to turn an off balanced piece -- which will occur if you leave it on the lathe overnight to dry un-equally. Four wheels would cover more situations, and it makes no difference what shape the arms are as long as you can get a good tight fit which might not be the case with a curved arm. Whatever your design is, make sure it has plenty of beef and is as riged as possible.