Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Glue for Wasteblocks

Posts

Glue for Wasteblocks

#1

Glue for Wasteblocks

Devo

>All,

Been playing with my new Escoulan Chuck doing facegrain bowls/platters. I've been using CA glue and accellerant without incident so far, but, I'd like to use something a little more cost effective. Would Titebond or Polyurethane Glue be acceptable assuming they had cured? (24 hours?)

Re: Glue for Wasteblocks

#2

Re: Glue for Wasteblocks

Norm Smith

>Hi Devon,

I use Tightbond 3 and never have a problem.

Norm

Re: Glue for Wasteblocks

#3

Re: Glue for Wasteblocks

Fog Tanner

>I never use CA glue on a joint that is subject to shearing forces, that is the weakness of that type of glue. I have the same chuck and have been using Titebond I with no problems. I have been putting the waste block on just before I shutdown at night and it is OK the next morning. I make sure the two mating surfaces are flat, a film of glue on both surfaces, and then use the tailstock as a clamp. I have done both eccentric and offcenter using this glue with no problems. It just isn't water resistant like Titebond II and III.

I wish that the screw and the hole were six point so you could rotate the outside without having to use the faceplate. Not a problem for the eccentric, but a pain for the offcenter. Other than that it is a neat chuck, offering new opportunities for ways to ruin a perfectly good piece of wood, but then they are art and not really ruined - just a change in expression.....

Re: Glue for Wasteblocks

#4

Re: Glue for Wasteblocks

Fog Tanner

>And I forgot, using the accelerator on the CA glue weakens the glue joint. I use it only for cosmetic applications such as filling where strength is not a real consideration.

Re: Glue for Wasteblocks

#5

Re: Glue for Wasteblocks

John Lucas

>I've been using CA glue with accelorator for many years to glue wasteblocks to pieces and haven't had a problem. In fact I use it so that I can remove it by using a sharp rap from a hammer and chisel. It doesn't destroy the wood or the glue block. I've used the same glue blocks for quite a while. However, whenever I'm in doubt I use either 5 minute epoxy or yellow glue. I buy the epoxy in the larger containers so it's very cost effective that way. I use the yellow glue when I'm not in a hurry and not glueing to green stock.

Re: Glue for Wasteblocks

#6

Tite-Bond II or III (only glue for me)

Ruth Niles

>

Re: Glue for Wasteblocks

#7

Re: Glue for Wasteblocks

Steve Worcester

>I use flexible CA, which seems to take much more shock that the non-flex. Also use accelerator. Use it all the time with my square turning. But if you have the time, yellow glue dried overnight works great.

Gorilla type glues don't fill gaps real well for that type of stress either because the foamed up portions don't have as much strength.

Steve Worcester

www.turningwood.com