Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

For the Inventors Out There

Posts

For the Inventors Out There

#1

Ric Taylor

For the Inventors Out There

Ric Taylor

>Many times when we complete the finishing process on our projects, we end up with a gloss finish. Sometimes that is planned and desired, sometimes it is not.

Often, turners will then use steel wool to reduce the gloss back towards a more matt finish. Many of us don't like to use steel wool for anything, for a variety of reasons. Wouldn't it be great if there was a buffing wheel and compound combination that could be used to reduce gloss to a matt finish instead of using steel wool? Perhaps a compound with a grit slightly more aggressive than tripoli.

Maybe there is something out there that I haven't heard of. Is anyone doing anthing like this?

Ric

Re: For the Inventors Out There

#2

3M non-woven abrasives

Phil Joines Krum, Tx

>Will cut back the shine without leaving iron bits in the pores of in your skin. There are at least two types, finishing and surface conditioning. Both come in a variety of grits. I don't buy the no name pads because the quality can vary considerably.

Perhaps someone can suggest of site with a good discussion of them.

Re: For the Inventors Out There

#3

Re: 3M non-woven abrasives

Ken Grunke from SW WI

>I believe the 3M pad you want is grey, but there's two grades that are grey and the other is quite a bit coarser--If memory serves me right, the light grey is the finest and dark is the coarser. Go to an auto parts store, they'll have it.

Neat thing about 3M pads is they stick to velcro. I use the stuff on my 2" sanding pad.

Re: For the Inventors Out There

#4

Leo Van Der Loo

this is what I use,

leo Van Der Loo

>Ric I use the abrasive pads, I have got them on a thread piece with washers and nuts, use these also for cleaning between burrs and taking off the fuzzies from willow burls and the like, I have used them in my high speed drill and in my polishers chuck, simple to make and works great, You can change to white or gray or green pads for finer or coarser in a heartbeat.

Have fun and take care

Leo Van Der Loo


img

Re: For the Inventors Out There

#5

Leo Van Der Loo

Re: this is what I use, 

leo Van Der Loo

>


img

Re: For the Inventors Out There

#6

Ric Taylor

Re: For the Inventors Out There

Ric Taylor

>Thanks for the responses. I'm still hoping to figure out a method using buffing wheels, but Ioe's setup certainly deserves some consideration.

Ric

Re: For the Inventors Out There

#7

Re: For the Inventors Out There

John Lucas

>Ric Look in some of the metal supplier catalogs. They often have a lot of buffing compounds but I think most are finer than tripoli. Also I would give Grizzly a call. I'm not sure they have anything course listed but they obviously have experimented with a lot of different types in their guitar making section.

Re: For the Inventors Out There

#8

Re: For the Inventors Out There

John Lucas

>I must be asleep. I meant to tell you to contact 3M. They have just about every type of abrasive you can imagine and many that we woodworkers never see. They might have just the thing your looking for.

Re: For the Inventors Out There

#9

Brad Vietje

Green is fairly coarse -- Rick probably wants gray

Brad Vietje

>