Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

This is my First Pen

Posts

This is my First Pen

#1

This is my First Pen

Samuel Brooks

>Everything felt smooth on the lathe, but when I put the pen together the stock is larger then the connection pieces. Is this common? I guess I should have used my calipers.

The kit is a 7mm from Rockler.

Thanks for any comments.

I used the HUT PPP finish process with the two colored sticks.


img

Re: This is my First Pen

#2

Nice Job on your 1st pen

Jake Niedling

>I don't turn alot of pens, except a few to give away. I usually make the standard 7mm slimline. I like the barrells of the pen to be a little thicker than the bushing. I think they feel better when you use them. I just make sure that the ends of the wooden barrells are turned down to match the bushings.

Re: This is my First Pen

#3

Re: Nice Job on your 1st pen

Lan Brady

>Samuel,

I have turne only a few pens, but have had the same problem.

My difference came from using bushings from Woodcraft store and pen kits from Rocklers. There is a slight difference. Remember, the 7mm is the interior size, not the outside diameter of the bushings.

good luck, Lan

Re: This is my First Pen

#4

Re: Nice Job on your 1st pen

Sam Brooks

>I am going to use my calipers on the next one which should take the suprise out of it. I was assuming since the bushing were from Rocker that everything would match.

Thanks,

Sam

Re: This is my First Pen

#5

Re: Nice Job on your 1st pen

Bill Hale / Woodspinner

>THERE IS THAT WOOR AGAIN.

ass u me

Bill in Dolores, CO