Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

How to remove bark from burl

Posts

How to remove bark from burl

#1

How to remove bark from burl

keith zimmerman, Normal, IL

>I bought a wonderful piece of maple burl at Louisville and was wondering how best to remove the bark from the burl.

Any ideas?

keithz

Re: How to remove bark from burl

#2

This is what I do....

TDaniel

>Most of my burl pieces are turned natural edge up. After I have turned the piece to almost final thickness I use a pick to remove the unwanted bark.

TD

Re: How to remove bark from burl

#3

Ric Taylor

Re: How to remove bark from burl

Ric Taylor

>You can blast the bark off with a high pressure water spray like those at a car wash.

Ric

Re: How to remove bark from burl

#4

Re: How to remove bark from burl

Bart Rhoads

>If you soak the burl in a tub of water, bark side in the water for a couple of days, it will blast off a lot easier. I have done this with mytrl burl several times so it should work on maple burl also.

Re: How to remove bark from burl

#5

Brad Vietje

Re: How to remove bark from burl

Brad Vietje

>If green, a rubber mallet usually works very well -- smack the wood at a slight angle and chunks of bark come off without damaging the fine points below. this works great for Boxelder and Cherry burls, at least.

If dry or nearly so, I like Terry's suggestion about pulling/picking it off later. If you don't want a natural edge, then I can't help -- I'd probably try the pressure wash method mentioned, but never have.

Safe spinning,

Brad Vietje

Newbury, VT