Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Jet 1236 speed control question

Posts

Jet 1236 speed control question

#1

Jet 1236 speed control question

Ken Grunke from SW WI

>I noticed on the 1236's speed control, I can get it lower than the lowest detent which might prove useful.

I was wondering if anyone has had the speed control apart, to know if new detent holes can be added (drilled or ?) or not.

Also, there is quite a jump in speed from the first to the second detent, and I'd like to add one in between if possible.

Any thoughts or experience on this?

Re: Jet 1236 speed control question

#2

Re: Jet 1236 speed control question

Ron in Drums PA

>Be careful, if you lower the speed by opening the reeves drive too much you can ruin the drive.

It's been over a year since I did this to my 1236 and I don't have the lathe in front of me right now, so if a few things a fuzzy let me know and I'll try and clear thing up when I look at the lathe tonight.

Open up your covers, turn on the lathe and set your speed to the lowest setting. Stop the lathe and take notice where the cogs are in relation to each other. You need at least an 1/8" "bite", any less and you can cause damage the lathe.

Look at the handle's base and you will notice two screws. Loosen them and remove the handle. on the shaft you will notice a "gear". Replace the handle while moving the shaft "up a notch". Replace the screws, turn on the lathe and check the reeves drive to make sure you have no less than an 1/8" bite. Make any adjusts you may need until you get it right. Most likely this is all you will need to do.

Step two (only if you are nuts)

In the headstock under the pulleys you will see another shaft below the spindle, on that shaft you will see a set screw. You can tweak a lower speed by making adjusts here also. Be careful, if you make to much of an adjustment the shaft will hit the pulley, so check the clearance before you turn on the lathe.

I bet doing this will void any warranty.

Good Luck

Re: Jet 1236 speed control question

#3

Re: Jet 1236 speed control question

chris rolke

>i cheat and use a zip tie around the speed control arm to the headstock clamp in i really need to go slow

doing this will cause the belt to wear out faster

Re: Jet 1236 speed control question

#4

Brad Vietje

Re: Jet 1236 speed control question

Brad Vietje

>Wasn't aware of the adjustment on the motor shaft, but you can drill another hole for the lower speed.

Safe spinning,

Brad Vietje

Newbury, VT

Re: Jet 1236 speed control question

#5

It's Funny...

George (Oxford, NC)

>I have the famed (or infamous) HF 34706, the Jet 1236 clone, and there is no movement below the first detent. Could the 'clone' have better or more precise engineering/machining?

George

Re: Jet 1236 speed control question

#6

Thanks

Ken Grunke from SW WI

>Thanks, Ron, Chris, and Brad for the ideas, I still haven't got a chance to try anything yet. Probably tomorrow!