Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Hot Spindle?

Posts

Hot Spindle?

#1

Hot Spindle?

Peter Teubel

>So I'm in my shop turning some small spindle work. Oneway 2436, running max speed (>3000), Steb center, very light tailstock pressure. The drive spindle is hot enough to get a 2nd degree burn. Outboard side is just warm. Belt is not super tight, but its not loose either. And this is after just about 10 minutes turning time! Doesn't seem normal to me.

Re: Hot Spindle?

#2

Re: Hot Spindle?

Mike Brazeau

>Peter - I don't know the exact details but I have seen this mentioned many times on various forums. My 2436 is 2 1/2 years old and only used for hobby work, but still runs very warm to almost hot after working for an hour or so. Has something to do with bearing run in.

Mike

Re: Hot Spindle?

#3

Re: Hot Spindle?

Allen Neighbors

>Peter, Oneway forum is the best place to check for posts on Spindle Overheating. http://www.oneway.com look in the left frame, and click on Oneway Forum.

My instructions said to not turn at high speed for a couple of hours or days, or something like that... I can't remember, and don't have the manual present.

There is a way to loosen the Spindle Bearing if it's too tight, but I'd be hesitant to mess with it. Best bet is to post a message to "kevin_clay" (without quotes) on the Oneway forum. He's the one to advise you better than me, for sure. :o)

Allen

Re: Hot Spindle?

#4

More details...

Peter Teubel

>Now its making a quiet screeching sound...louder when the tailstock is pressing against the spindle...less, but still there when its not. My guess would be the thrust bearing is toast. It get HOT within minutes. Needless to say, I'm not turning on it.

Well, it certainly didn't happen from USE, considering just been sitting in my shop unplugged for the past year. I'll be calling Oneway first thing in the morning.

Re: Hot Spindle?

#5

Resolution...

Peter Teubel

>Just got off the phone with Kevin at Oneway. He mentioned that the spindle needs to break in so it shouldn't be run at full speed for several hours and during that time it will get very warm. But the screeching noise and the fact that with NO tailstock pressure the spindle starts to get warm within 30 seconds is NOT a good thing. They are shipping me a new spindle assembly.

I hope they will follow up with me the root cause of the problem once they get the old spindle back. Perhaps because it sat unused for so long, maybe condensation got into the bearings and caused rust or something. I dunno.

BUT, it give creedence to the saying " You don't use it, you lose it!".