Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Any Secret to Removing Insert from Chuck?

Posts

Any Secret to Removing Insert from Chuck?

#1

Any Secret to Removing Insert from Chuck?

Charlie Anderson

>I'm changing the insert from a 1" to a 1 1/4" but the current insert seems to be firmly, after 2 years, in place.

Any ideas?

I would just use a spindle adapter but I'm worried about runout although for $60 the adapter should be pretty true.

Re: Any Secret to Removing Insert from Chuck?

#2

Re: Any Secret to Removing Insert from Chuck?

Stuart Johnson

>Did you remember to remove the set screws? Other than that, you might clamp the jaws down on something and using a big wrench.

Re: Any Secret to Removing Insert from Chuck?

#3

Ric Taylor

Re: Any Secret to Removing Insert from Chuck?

Ric Taylor

>The screws on the adapter should push it right out.

Ric

Re: Any Secret to Removing Insert from Chuck?

#4

If it's a Oneway

Bill Howatt

>Remove the screws holding the adapter to the chuck. Put 2 of them in the threaded holes and evenly tighten them; they will push the tapered adapter out of the chuck body.

Bill

Re: Any Secret to Removing Insert from Chuck?

#5

Brad Vietje

What kind of chuck, Charlie ?

Brad Vietje

>

Re: Any Secret to Removing Insert from Chuck?

#6

Re: What kind of chuck, Charlie ?

Charlie Anderson

>No set screws.

It's a SuperNova.

Re: Any Secret to Removing Insert from Chuck?

#7

Thanks everybody

Charlie Anderson

>A little PB Blaster and brute force did it.

Re: Any Secret to Removing Insert from Chuck?

#8

Re: What kind of chuck, Charlie ?

Jorge Castaneda ~ Downeast Maine

>Charlie, I have the Supernova too, it has between the two big holes to open and close the jaws, two smaller holes, about 6mm and one of them is a dud, tthe other has a set screw there, you will need a 3 mm hex wrench, loosen it, lock the spindle and remove the chuck, then you will need an adjustable wrench to remove the adapter.

Jorge

Re: Any Secret to Removing Insert from Chuck?

#9

Re: What kind of chuck, Charlie ?

Carole Valentine

>Charlie, you should definitely have at least one set screw. If you don't, you are lucky the insert didn't unwind on you! It's hard to see down in that hole.

Re: Any Secret to Removing Insert from Chuck?

#10

A friend of mine always says...

Gary Evans Tallassee, TN

>brute force and ignorance properly applied can do anything.

Gary