Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Don't try this at home!

Posts

Don't try this at home!

#1

Don't try this at home!

Gary in Zirconia, NC

>This is my lathe (Demo lathe from Samson room) being loaded after the symposium was over. This is not the normal way Oneway loads lathes, but since my van was right outside the room the lathe was in and there happened to be a stack of cement blocks near by, Kevin just jacked the lathe up and slid it in.


img

Re: Don't try this at home!

#2

Re: Don't try this at home! 

Gary in Zirconia, NC

>


img

Re: Don't try this at home!

#3

now we need ...

e

>...the pictures of you getting it out of your van!

congrats on a GREAT lathe

Re: Don't try this at home!

#4

JL

Re: Watch out for your back this time..

JL

>

Re: Don't try this at home!

#5

Needs a goat tag

tek-Brunswick, Ohio

>

Re: Don't try this at home!

#6

oops I meant gloat!

tek-Brunswick, Ohio

>

Re: Don't try this at home!

#7

JL

Re: That a Freudian Slip??

JL

>

Re: Don't try this at home!

#8

I just...

Ken Grunke from SW WI

>threw my back out looking at the second pic!

Re: Don't try this at home!

#9

Re: I just...

Stuart Johnson

>That bowed board would have given me a heart attack. It it snapped that end would have dropped and the other end would have driven the other guys head through the roof. When do we see the unloading pictures?

Re: Don't try this at home!

#10

Yeah, my thoughts too.

Eddie Pacheco, San Jose, Ca.

>

Re: Don't try this at home!

#11

Unloading

Gary in Zirconia, NC

>Here's a shot of how I unloaded it. Note the old bumper jack in the photo. I just jacked it up an inch and pushed it 2 inches, then repeated till I got it in the garage. Then jacked it up and put a dolly under it and rolled it into my shop. The heavy part was putting the headstock on.


img