Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Delta Lathe Caution

Posts

Delta Lathe Caution

#1

Delta Lathe Caution

Roger

>I have had an ongoing problem with the speed controller on my Delta 46-755X 16� lathe. When setting the speed above 2400 RPM, stopping the lathe via the �STOP� button and restarting the lathe with the �RUN� button the lathe will spin up to around 2400RPM and immediately slow down to around 300 RPM. Delta replaced the controller twice with varying results. The last controller does the same thing but only with the �Acceleration/Deceleration� switch set to �FAST�. It functions properly when the switch is set to �SLOW�. Delta�s final response to me was �Don�t set the switch to Fast and live with it�. This is not what I expected from Delta as they have had a great reputation for support, I would surmise that this is what we can expect in the future as Delta is now governed by Black & Decker. This is my last Delta purchase.

Roger

Re: Delta Lathe Caution

#2

Re: Delta Lathe Caution

Wilford Bickel

>Are you talking to the TECH or just the Customer Service contacts. When I had a problem we had to insist on the Tech calling us and it got straightened out - the CS contacts just read off the screen and they have at least one woman they need to get rid of immediately. She even argued with me as to what lathe I owned! The TECH gave great service.

Wilford

Re: Delta Lathe Caution

#3

Re: Delta Lathe Caution

Roger

>Wilford,

According to the tech that I talked to the problem was referred to Delta Engineering and this is Engineering�s response to me. This is akin to telling your doctor that your lungs hurt when you breath, and the doctor telling you don�t breath then and it wont hurt

Roger

Re: Delta Lathe Caution

#4

Re: Delta Lathe Caution

Wilford Bickel

>I would get back in touch with the TECH and tell them you will not accept this solution. You want the lathe fixed or replaced.

Re: Delta Lathe Caution

#5

Re: Delta Lathe Caution

Bill Hale / Woodspinner

>It is to bad when a good company is bought out because of their sales and the new company destroys any reputation they bought the company for.

It seems anything I have read about Delta lately has been bad.

Not a company you want to buy from anymore.

Bill in Casa Grande, AZ -- Just added central air to the shop.