Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Warpage?

Posts

Warpage?

#1

Warpage?

Keith I - East Tn

>Hi folks,

I recently agreed to donate a lidded box/bowl to a charity based in Tucson, AZ. and finished it a couple of weeks ago. It was cut from green ash then alcohol dried and finish turned. It has been sitting inside my house since it was finished and is stable. IE no warpage or anything. My question is, will the dry AZ air cause the lid to warp do you think?

Thanks,

Keith

Re: Warpage?

#2

Re: Warpage?

Dave Belser

>If it's turned spindle wise (tree runs length of lathe) you are probably OK, otherwise it will likely warp wherever you send it.

- Dave

Re: Warpage?

#3

Re: Warpage?

Steven Potts

>How long after you let it soak did it sit around to dry? I use this same method and I soak and then let sit in shop for at least 4 weeks or more, but I turn rather large objects, with roughed out thickness around an 1" to 1" 1/4. So it depends on thickness.

Re: Warpage?

#4

Re: Warpage?

John Lucas

>Keith I'm not familiar with the alcohol drying. If I need a box in a hurry I rough it out and microwave it until it's really dry. Then I let it sit in the shop for a day to pick up some moisture. Even if it's turned end grain it will move but it depends on the species and how big the box is as to whether or not it will be a problem. Also depends on how dry your house is. I would assume that it would by dryer in Az compared to here in Tennesse, even indoors with air.

Re: Warpage?

#5

Wally?

Carole Valentine

>Seems like Wally or some of our other folks in AZ should be able to answer this question. I am sure they have pieces that were created in a moister climate.

Re: Warpage?

#6

Re: Warpage?

Keith I - East Tn

>The box was turned end grain, to about 1/2" thick before soaking, then dried for a week before finishing. It then was placed indoors for about two weeks. The lid rocks just a little but is not visable and could still correct if I need to. Finished dims is 7 1/2 x 3".

Thanks,

Keith


img

Re: Warpage?

#7

Re: Warpage?

john lucas

>Keith I looked up the shrinkage rate for ash and it's 7.8 percent across the grain and 4.6 with the grain so you lid will tend to go oval. This is from wet to dry. Since your only changing from dry in Tn to Dry in AZ it won't be that great. You would have to know the EMC of Tn vs AZ to calculate the movement. I have a chart somewhere that shows aproximate seasonal movement but I can't find it yet. I'll keep moving. With a bowl 7 1/2" in diameter I think you will get at least 1/16" movementon the sides parallel to the grain but that's just an educated guess. My charts apparently got misplaced when I moved and i'll just have to dig further to give you a better idea.

Re: Warpage?

#8

Re: Warpage?

Keith I - East Tn

>Thanks John, If you just happen to run across the info that would be great but don't go to anymore trouble. I made the lid to fit a little sloppy so if it only moves 1/16th then no worrys.Thanks again,

Keith