Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

non-slip mat?

Posts

non-slip mat?

#1

non-slip mat?

dwfII

>What is it that everyone is using at the end of a jam chuck to drive a bowl or hollowform from the inside? I need to part my hollowform from the base and I have turned a "post"--not really a jam chuck because it doesn't fit tightly (real close but no stress)--in the opening. The post does go all the way to the bottom of the HF, so if I can glue something to the end,so that the HF will not slip, I can mount it between centers and part it off.

So...again, what is the stuff and where do you get it?

DW

In the High Desert of Central Oregon

Re: non-slip mat?

#2

Re: non-slip mat?

Russell L. Babbitt Jr.

>An old mouse pad, kitchen shelf liner, a piece of sandpaper.

Re: non-slip mat?

#3

Re: non-slip mat?

Barry Irby

>I use cheap carpet pad. Mine is pink, but I think it comes in other colors. what I use is made of a singe piece o stuff rather than the type made of "crumbles". I pick up scraps off construction sites, but a carpet shop will probably give you a scrap. A yard will last along time. I just put a piece of it in the hf and then fish it out with a hooked wire.

Re: non-slip mat?

#4

Re: non-slip mat?

Keith I - East Tn

>I use tool box liner from home depot but I saw the same stuff at wall- mart with the shelf paper. Comes in big rolls that will last forever. I use it for a router pad also.

Keith

Re: non-slip mat?

#5

Re: non-slip mat?

Terry Quiram, Roanoke Illinois

>I use 1/2" carpet pading.