Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Dyes, Coloring questions

Posts

Dyes, Coloring questions

#1

Dyes, Coloring questions

Chip in Plano

>I would like to get some feedback/tips on introducing color into my projects with tints, dyes, etc. What woods work best? What products are you folks using and techniques? Bleeding caused by dyes following the natural wood grain is the first thing I noticed when playing around. I tried to retard it with various other finishes on hand without any education: danish oil, tung oil, Deft, 1/2# shellac cuts. How do you control the affect? I did layer some of the tints and got some interesting results, too.

Re: Dyes, Coloring questions

#2

Re: Dyes, Coloring questions *LINK*

Russell L. Babbitt Jr.

>Take a look at the link below you will find three pieces that I have added color to. The Saturn bowl, and the platter have analine dye applied. The bowl out of maple was nothing more than just a permanent marker used. Both dyed pieces were hard maple so there was very little bleed thru. On bowls of this shape I could have used a marker and added an accent on the edge of the rim to hide any bleed thru. The saturn bowl used two colors applied by a method Jimmy Clewes uses in his DVD Turnaround, check it out. The maple bowl with the black stripe did have some bleed thru on the edges so I used a woodburner to hide/accent it.


Russ Babbitt Jr. Gallery

Re: Dyes, Coloring questions

#3

Did you put...

Ted Owen, Pittsburgh

>the dye on bare wood? What kind of wood? Try a thin wash coat of 1-lb shellac on the bare wood, sand lightly with 320, then dye.

Best, Ted

Re: Dyes, Coloring questions

#4

Re: Did you put...

Russell L. Babbitt Jr.

>All of my dyeing has been on bare wood. I will try the shellac you mentioned.

Re: Dyes, Coloring questions

#5

Re: Dyes, Coloring questions

Joe Flemig

>Chip,

I have done a lot of dye work and have found the following:

1 - Analine dyes are very thin. They will go right through porous woods. When dyeing an ash vessel, I've had dye go in the bottom, slosh around inside and come back out. It is very difficult to control the amount of dye with a rag application. I use an airbrush now.

2 - Dyes are transparent. In other works, the colors do not cover each other; they add to each other. This includes the color of the wood. Keep that in mind when aaplying blue dye to green wood.

3 - Whatever the solvent of the topcoat, keep in mind that it could reactivate the dye and cause it to bleed and run. Shellac is often used as a barrier coat. I use use a light coat of lacquer for my pieces to protect the dye.

Joe Fleming - San Diego