Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Greetings

Posts

Greetings

#1

Greetings

nailed_nailer

>Hello all.

I have been a lurker in here for going on 4 years. I really enjoy the quality of posters and their work. I have held off contributing due to not wanting to get wrapped up in yet another messageboard. But you guys have drawn me in. All I can say is that you guys and gals will never know how many ways you have helped me out over the years. Your postings, tips, and tecniques are an unbelievable asset to the turning world.

About myself:

Active hobby turner for 5 years or so. Member in the AAW and one of the Project directors for my local chapter. I turn mostly bowls and vessels. Usually from local hardwood. I give most of it away to friends and neighbors but ocassionally sell some things. I turn on a Nova 3000 that I bought used off Barbara Gill several years ago (Hi Barbara). I have a wife, a daughter, and a son. We live out on Cape Cod, MA.

And,

I have a question for you all.

Somewhere I read an article on vibration dampening using a vertical post with a top weight attached to the lathe near the headstock. I was in a chat room last night and told someone I would link them to the article. But now I can't find it. Can anyone remember where I saw that article?

Thanks again,

---nailed_nailer---

Re: Greetings

#2

Re: Greetings

John Lucas

>I know there was an article in More Woodturning magazine years ago. I think I've also seen one on the net. You can probably do a search for More Woodturning or Fred Holder and find that information. It was an interesting article and I had a Nova 3000 back then so I needed vibration dampening. I sold it and bought a Powermatic so vibration isn't much of a problem anymore.

Re: Greetings

#3

Re: Greetings

John Lucas

>Found the name of the article and issue. Don't know if you can order back issues from Fred or not.

Glaser tunable vibration absorber for lathes June 2002 vol7 no 5.

I do remember there was a problem of people using standard all-thread to make the device and it get fatique cracks and fall off the lathe. He recommended some sort of stronger all-thread. I don't think it was in that article but was in a letter to the editor of something afterword.

Re: Greetings

#4

Re: Greetings

nailed_nailer

>John,

Thanks for looking but that isn't what I remember from the article. The one I saw was homemade. It was something like a 2" diameter pole attached to the headstock area that supported a deadweight ~20lbs. There was some physics behind it something about a moment arm and antivibration increasing the higher you put the deadweight.

Thanks for looking,

---Nailer---

Re: Greetings

#5

Here *LINK*

Mark Mandell - Gone Round In Jersey

>If the link still works to John's site.


Damping

Re: Greetings

#6

Re: Greetings

John Lucas

>That was the article. He used a piece of commercial all-thread to hold the weight out from the headstock. The weight was then adjusted up and down until you hit the harmonic that stopped the vibration. It was homemade although Jerry Glaser may have sold some.

Re: Greetings

#7

Re: Greetings

nailed_nailer

>John, thank you. That is what I was talking about. But, not the same article I remember. But I appreciate your efforts.

Mark, That is the one. Thank You!!!

Thanks again,

---Nailer---