Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Jimmy Clewes Oriental Box Question

Posts

Jimmy Clewes Oriental Box Question

#1

Jimmy Clewes Oriental Box Question

Ed Moore

>As one who watched Jimmy Clewes turn an oriental box (winged vessel) at around 3000 RPM at the OVWG Symposium last October, I am hoping others have seen him do this in person or on his DVDs. My question is simple:

What tool or tools did Jimmy use on the winged portion of the box?

Yes, I plan to get those DVDs and I may even get a DVD player so that I can see them somewhere besides on this computer. ;^D

My guess as to the answer to my question is a spindle or detail gouge held almost vertically.

Thanks for your help.

Ed

Re: Jimmy Clewes Oriental Box Question

#2

Re: Jimmy Clewes Oriental Box Question

Jim Shaver Oakville, Ont.

>Hi Ed,

I just checked my notes from the April demo he did at our club. He said it was a 1/2" gouge (it was not a spindle gouge in my notes, or I would have noted that), he said in the UK they measure the width of the flute for gouge size, in North America we measure the diameter of the bar stock...so, it would be 1/2" flute. He turned it in a normal attitude; I do not remember seeing him with the tool in a vertical orientation. I know that he did cut the top of the winged foot against the grain our at the tip, about a 1/2 -3/4" only since it was essentially flat and not UP hill.

Hope that helps,

Take care,

Jim

Re: Jimmy Clewes Oriental Box Question

#3

Re: Jimmy Clewes Oriental Box Question

Ed Moore

>Thanks to Mike Brazeau I now know that Jimmy used a 1/2" bowl gouge and a pull cut when he did the tip of the wings on the oriental box.

I may try one soon, but not at 3000 RPM. ;^D

Ed

Re: Jimmy Clewes Oriental Box Question

#4

Re: Jimmy Clewes Oriental Box Question

Rick Allen

>The reason for the 3000 RPM is so you can get a clean cut on the wing. At slower RPMs the tool tends to fall into the void. The result being that the leading edge of the wing is thinner than the trailing edge.

You can of course do the wings at a slower RPM. It is just more dificult to control the cut.

Good Luck